Инструкции По Установке для 3com S7906E

 

1-40 

[SwitchA-Vlan-interface100] quit 

[SwitchA] interface vlan-interface 101 

[SwitchA-Vlan-interface101] ip address 1.1.1.1 255.255.255.0 

[SwitchA-Vlan-interface101] quit 

# Create an interface named Tunnel 1. 

[SwitchA] interface tunnel 1 

# Configure an IPv4 address for interface Tunnel 1. 

[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0 

# Configure the tunnel encapsulation mode. 

[SwitchA-Tunnel1] tunnel-protocol gre 

# Configure the source address of interface Tunnel 1 to be the IP address of the VLAN interface. 

[SwitchA-Tunnel1] source vlan-interface 101 

# Configure the destination address for interface Tunnel 1. 

[SwitchA-Tunnel1] destination 2.2.2.2 

[SwitchA-Tunnel1] quit 

# Create service loopback group 1, setting the service type to tunnel. 

[SwitchA] service-loopback group 1 type tunnel 

# Add interface GigabitEthernet 2/0/3 to service loopback group 1. 

[SwitchA] interface GigabitEthernet 2/0/3 

[SwitchA-GigabitEthernet2/0/3] undo stp enable 

[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1 

# Apply service loopback group 1 to the tunnel in tunnel interface view. 

[SwitchA-GigabitEthernet2/0/3] quit 

[SwitchA] interface tunnel 1 

[SwitchA-Tunnel1] service-loopback-group 1 

[SwitchA-Tunnel1] quit 

# Configure a static route from Switch A through interface Tunnel 1 to Group 2. 

[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1 

2)  Configure Switch B 

# Configure an IPv4 address. 

<SwitchB> system-view 

[SwitchB] interface vlan-interface 100 

[SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0 

[SwitchB-Vlan-interface100] quit 

[SwitchB] interface vlan-interface 101 

[SwitchB-Vlan-interface101] ip address 2.2.2.2 255.255.255.0 

[SwitchB-Vlan-interface101] quit 

# Create an interface named Tunnel 1. 

[SwitchB] interface tunnel 1 

# Configure an IPv4 address for interface Tunnel 1. 

[SwitchB-Tunnel1] ip address 10.1.2.2 255.255.255.0