Инструкции По Установке для 3com S7906E
1-6
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enable a RIP process and
enter RIP view
enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
[ vpn-instance
vpn-instance-name ]
Required
Not enabled by default
Enable RIP on the interface
attached to the specified
network
attached to the specified
network
network network-address
Required
Disabled by default
z
If you make some RIP configurations in interface view before enabling RIP, those configurations
will take effect after RIP is enabled.
z
RIP runs only on the interfaces residing on the specified networks. Therefore, you need to specify
the network after enabling RIP to validate RIP on a specific interface.
z
You can enable RIP on all interfaces using the command network 0.0.0.0.
z
If a physical interface is attached to multiple networks, you cannot advertise these networks in
different RIP processes.
Configuring the interface behavior
Follow these steps to configure the interface behavior:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
[ vpn-instance
vpn-instance-name ]
––
Disable an or all interfaces from
sending routing updates (the
interfaces can still receive
updates)
sending routing updates (the
interfaces can still receive
updates)
silent-interface
{ interface-type
interface-number | all }
{ interface-type
interface-number | all }
Optional
All interfaces can send routing
updates by default.
updates by default.
Return to system view
quit
—
Enter interface view
interface interface-type
interface-number
interface-number
—
Enable the interface to receive
RIP messages
RIP messages
rip input
Optional
Enabled by default
Enable the interface to send
RIP messages
RIP messages
rip output
Optional
Enabled by default
Configuring a RIP version
You can configure a RIP version in RIP or interface view.