Инструкции По Установке для 3com S7906E
1-11
To do…
Use the command…
Remarks
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
[ vpn-instance
vpn-instance-name ]
––
Configure the filtering of
incoming routes
incoming routes
filter-policy { acl-number |
gateway ip-prefix-name |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] }
import [ interface-type
interface-number ]
gateway ip-prefix-name |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] }
import [ interface-type
interface-number ]
Required
Not configured by default
Configure the filtering of
outgoing routes
outgoing routes
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ protocol [ process-id ] |
interface-type
interface-number ]
ip-prefix ip-prefix-name }
export [ protocol [ process-id ] |
interface-type
interface-number ]
Required
Not configured by default
z
Using the filter-policy import command filters incoming routes. Routes not passing the filtering
will be neither installed into the routing table nor advertised to neighbors.
z
Using the filter-policy export command filters outgoing routes, including routes redistributed with
the import-route command.
Configuring a Priority for RIP
Multiple IGP protocols may run in a router. If you want RIP routes to have a higher priority than those
learned by other routing protocols, you can assign RIP a smaller priority value to influence optimal route
selection.
Follow these steps to configure a priority for RIP:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
[ vpn-instance
vpn-instance-name ]
––
Configure a priority for RIP
preference [ route-policy
route-policy-name ] value
route-policy-name ] value
Optional
100 by default
Configuring RIP Route Redistribution
If a router runs RIP and other routing protocols, you can configure RIP to redistribute OSPF, IS-IS, BGP,
static, or direct routes.
Follow these steps to configure RIP route redistribution:
To do…
Use the command…
Remarks
Enter system view
system-view
––