Инструкции По Установке для 3com S7906E
1-15
Configuring OSPFv3 GR
You cannot configure OSPFv3 GR after configuring OSPFv3 virtual links, becase they are not
supported at the same time.
To prevent service interruption after a master/backup switchover, a GR Restarter running OSPFv3 must
complete the following tasks:
z
Keep the GR Restarter forwarding entries stable during reboot.
z
Establish all adjacencieis and obtain complete topology information after reboot.
After the master/backup switchover, the GR Restarter sends a Grace-LSA to tell its neighbors that it
performs a GR. Upon receiving the Grace-LSA, the neighbors with the GR Helper capability enter the
helper mode (and are thus called GR Helpers). Then, the GR Restarter retrieves its adjacencies and
LSDB with the help of the GR Helpers. Thus, the normal data forwarding is ensured.
Configuring GR Restarter
You can configure the GR Restarter capability on a GR Restarter.
Follow these steps to configure GR Restarter:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Enable the GR capability
graceful-restart enable
Required
Disabled by default.
Configure the GR interval
graceful-restart interval
interval-value
interval-value
Optional
120 seconds by default.
Configuring GR Helper
You can configure the GR Helper capability on a GR Helper.
Follow these steps to configure GR Helper
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Enable the GR Helper
capability
capability
graceful-restart helper enable
Optional
Enabled by default.