Справочное Руководство для 3com S7906E

 

1-43 

group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters. 

ipv4-address: IPv4 address of a peer. 

ipv6-address: IPv6 address of a peer. 

route-policy-name: Specifies route-policy name, a string of 1 to 19 characters. 

import: Applies the routing policy to routes from the peer (group). 

export: Applies the routing policy to routes sent to the peer (group). 

Use the peer route-policy command to apply a routing policy to routes incoming from or outgoing to a 

peer or peer group.  

Use the undo peer route-policy command to remove the configuration. 

By default, no routing policy is specified for the peer (group). 

Use of the peer route-policy command does not apply the if-match interface clause defined in the 

routing policy. Refer to Routing Policy Commands in the IP Routing Volume for related information. 

# Apply the routing policy test-policy to routes received from the peer group test. 

<Sysname> system-view 

[Sysname] route-policy test-policy permit node 10 

[Sysname-route-policy] if-match cost 10 

[Sysname-route-policy] apply cost 65535 

[Sysname-route-policy] quit 

[Sysname] bgp 100 

[Sysname-bgp] ipv6-family 

[Sysname-bgp-af-ipv6] group test external 

[Sysname-bgp-af-ipv6] peer test route-policy test-policy import 

peer { ipv6-group-name | ipv6-address } route-update-interval interval 

undo peer { ipv6-group-name | ipv6-address } route-update-interval 

IPv6 address family view 

2: System level 

ipv6-group-name: Name of a peer group, a string of 1 to 47 characters. 

ipv6-address: IPv6 address of a peer.