Справочное Руководство для 3com S7906E

 

1-4 

Table 1-2 display dldp statistics command output description 

Interface Port 

index 

Packets sent 

Total number of DLDP packets sent 

Packets received 

Total number of DLDP packets received 

Invalid packets received 

Number of the invalid packets received 

Loop packets received 

Number of the loopback packets received 

Authentication failed packets received 

Number of the received packets that failed to pass 
the authentication 

Valid packets received 

Number of the valid packets received 

 

dldp authentication-mode { md5 md5-password | none | simple simple-password } 

undo dldp authentication-mode 

System view 

2: System level 

md5  md5-password: Specifies to perform MD5 authentication and sets the password. The 

md5-password argument is the password, a string of 1 to 16 characters or a 24-bit string. The former 

indicates a plain text password and the latter indicates a cipher text password. Note that this argument 

is case-sensitive. 

None: Specifies not to perform authentication. 

simple  simple-password: Specifies to perform plain text authentication and sets the password. The 

simple-password argument is the password, a case-sensitive string of 1 to 16 characters. 

Use the dldp authentication-mode command to configure DLDP authentication.  

Use the undo dldp authentication-mode command to restore the default. 

By default, DLDP authentication is not performed. 

To enable DLDP to operate properly, make sure the DLDP authentication modes and the passwords of 

the both sides of a link are the same. 

# Configure to perform plain text authentication, setting the password as abc (assuming that Device A 

and Device B are connected by the DLDP link).