Справочное Руководство для 3com S7906E

 

1-14 

mld-snooping host-aging-time interval 

VLAN view 

2: System level 

interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.  

Use the mld-snooping host-aging-time command to configure the aging time of dynamic member 

ports in the current VLAN.  

Use the undo mld-snooping host-aging-time command to restore the system default.  

By default, the dynamic member port aging time is 260 seconds.  

This command takes effect only if MLD Snooping is enabled in the VLAN.  

Related commands: host-aging-time.  

# Set the aging time of dynamic member ports to 300 seconds in VLAN 2.  

<Sysname> system-view 

[Sysname] vlan 2 

[Sysname-vlan2] mld-snooping host-aging-time 300 

mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id 

undo mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id 

Ethernet interface view, Layer 2 aggregate interface view, port group view 

2: System level 

ipv6-group-address: Address of IPv6 multicast group which the simulated host is to join. The effective 

range is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any 

hexadecimal number between 0 and F, inclusive.