Справочное Руководство для 3com S7906E

 

1-4 

2: System level 

interface-type interface-number: Port type and port number.  

master: Specifies a port as the master port.  

slave: Specifies a port as the slave port.  

Use the port command to assign the specified port as the master or slave port of the current smart link 

group.  

Use the undo port command to remove the specified port from the smart link group.  

Note that: 

z 

Disable STP and RRPP on the ports you want to add to the smart link group, and make sure that 

the ports are not member ports of any aggregation group or service loopback group. On the other 

hand, you cannot enable STP or RRPP on a smart link group member port or assign a smart link 

group member port to an aggregation group or service loopback group.  

z 

You can assign a port to a smart link group with the port smart-link group command in Ethernet 

interface view or Layer-2 aggregate interface view.  

Related commands: port smart-link group.  

# Configure GigabitEthernet 2/0/1 as the slave port of smart link group 1.  

<Sysname> system-view 

[Sysname] interface GigabitEthernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] stp disable 

[Sysname-GigabitEthernet2/0/1] quit 

[Sysname] smart-link group 1 

[Sysname-smlk-group1] protected-vlan reference-instance 0 

[Sysname-smlk-group1] port GigabitEthernet 2/0/1 slave 

port smart-link group group-id { master | slave } 

undo port smart-link group group-id 

Ethernet interface view, Layer-2 aggregate interface view 

2: System level 

group-id: Smart link group ID. The minimum value is 1, while the maximum value is 48.