Справочное Руководство для 3com S7906E

 

3-14 

z 

The IP addresses of the primary and secondary authorization servers cannot be the same. 

Otherwise, the configuration fails.  

z 

The HWTACACS service port configured on the device and that of the HWTACACS server must be 

consistent. 

z 

If you configure the command for more than one time, the last configuration takes effect.  

z 

You can remove an authorization server only when no active TCP connection for sending 

authorization packets is using it.  

Related commands: display hwtacacs. 

# Configure the secondary authorization server. 

<Sysname> system-view 

[Sysname] hwtacacs scheme hwt1 

[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49 

undo stop-accounting-buffer enable 

HWTACACS scheme view 

2: System level 

None 

Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting 

requests getting no responses.  

Use the undo stop-accounting-buffer enable command to disable the device from buffering 

stop-accounting requests getting no responses.  

By default, the device is enabled to buffer stop-accounting requests getting no responses. 

Since stop-accounting requests affect the charge to users, a NAS must make its best effort to send 

every stop-accounting request to the HWTACACS accounting servers. For each stop-accounting 

request getting no response in the specified period of time, the NAS buffers and resends the packet until 

it receives a response or the number of transmission retries reaches the configured limit. In the latter 

case, the NAS discards the packet.  

Related commands: reset stop-accounting-buffer, 

hwtacacs scheme, 

stop-accounting-buffer.