Справочное Руководство для 3com S7906E

 

1-32 

Use the ospfv3 peer command to specify a neighbor and the DR priority of the neighbor. 

Use the undo ospfv3 peer command to remove the configuration. 

A router uses the priority set with the ospfv3 peer command to determine whether to send a hello 

packet to the neighbor rather than for DR election. 

# Specify the neighbor fe80::1111. 

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] ospfv3 peer fe80::1111 

ospfv3 timer dead seconds [ instance instance-id ] 

undo ospfv3 timer dead [ instance instance-id ] 

Interface view 

2: System level 

seconds: Dead time in seconds, ranging from 1 to 65535. 

instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.  

Use the ospfv3 timer dead command to configure the OSPFv3 neighbor dead time for an interface that 

belongs to a specified instance.  

Use the undo ospfv3 timer dead command to restore the default.  

By default, the OSPFv3 neighbor dead time is 40 seconds for P2P and Broadcast interfaces, and is not 

supported on P2MP and NBMA interfaces at present.  

OSPFv3 neighbor dead time: if an interface receives no hello packet from a neighbor after dead time 

elapses, the interface will consider the neighbor dead.  

The  dead  seconds value is at least four times the Hello  seconds value and must be identical on 

interfaces attached to the same network segment.