Руководство Пользователя для Insignia NS-LDVD19Q-10A
43
www.insigniaproducts.com
Maintaining
Cleaning the cabinet
Wipe the front panel and other exterior surfaces of
your TV/DVD combo with a soft cloth lightly
dampened with lukewarm water. Never use a
solvent or alcohol to clean your TV/DVD combo. Do
not spray insecticide near your TV/DVD combo.
Such chemicals may cause damage and
discoloration to the exposed surfaces.
your TV/DVD combo with a soft cloth lightly
dampened with lukewarm water. Never use a
solvent or alcohol to clean your TV/DVD combo. Do
not spray insecticide near your TV/DVD combo.
Such chemicals may cause damage and
discoloration to the exposed surfaces.
Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold the
disc by the edges so that fingerprints do not get on
the surface. Never stick paper or tape on the disc.
disc by the edges so that fingerprints do not get on
the surface. Never stick paper or tape on the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of heat,
and never leave it in a parked car exposed to direct
sunlight.
expose the disc to direct sunlight or sources of heat,
and never leave it in a parked car exposed to direct
sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause poor
picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe the
disc from the center out.
picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe the
disc from the center out.
Do not use strong solvents such as alcohol, benzine,
thinner, commercially available cleaners, or
anti-static spray intended for older vinyl records.
thinner, commercially available cleaners, or
anti-static spray intended for older vinyl records.
Troubleshooting
TV
DVD player
Note
Never operate your TV/DVD combo immediately
after moving it from a cold location to a warm
location. Leave it for two or three hours without
operating it. If you use your TV/DVD combo in such a
situation, it may damage discs or internal parts.
after moving it from a cold location to a warm
location. Leave it for two or three hours without
operating it. If you use your TV/DVD combo in such a
situation, it may damage discs or internal parts.
Problem
Solution
No picture or sound
•
Check all cable connections.
•
Make sure that your TV/DVD combo is turned on.
Picture is OK, but no
sound
sound
•
Check the volume level and mute setting.
Sound is OK, but no
color
color
•
Check the color control and adjust it.
•
Check the program’s color features because it may be
a black and white movie.
a black and white movie.
The picture has
overlapped images
overlapped images
•
Make sure that the antenna is installed correctly. If
not, adjust the antenna towards the broadcasting
station.
not, adjust the antenna towards the broadcasting
station.
Picture has snow
•
Check the antenna and its connection. If there are
problems, correct them. If all connections are tight,
the problem may be with a faulty antenna or cable.
problems, correct them. If all connections are tight,
the problem may be with a faulty antenna or cable.
•
Check car traffic or neon signs that may disrupt the
image.
image.
Stripes on picture
•
Check for interference from other electronic devices,
such as radios and televisions, and keep magnetic or
electronic devices away from your TV/DVD combo.
such as radios and televisions, and keep magnetic or
electronic devices away from your TV/DVD combo.
Bad stereo or SAP
sound
sound
•
A long broadcast distance or interference from radio
waves can cause bad sound reception. Try changing
the mode to Mono.
waves can cause bad sound reception. Try changing
the mode to Mono.
Remote control does
not work
not work
•
Remove obstacles between the remote control and
the remote control sensor on the front of your
TV/DVD combo.
the remote control sensor on the front of your
TV/DVD combo.
•
Point the remote control at your TV/DVD combo’s
remote control sensor.
remote control sensor.
•
Install fresh batteries.
“Unsupported Mode”
appears on the screen
appears on the screen
•
Check the resolution and frequency of your computer,
and adjust it to the optimum resolution for your
TV/DVD combo: 1360 × 768 at 60 Hz.
and adjust it to the optimum resolution for your
TV/DVD combo: 1360 × 768 at 60 Hz.
“No Signal” appears on
the screen
the screen
•
Make sure that the cable is firmly connected to the
computer and TV/DVD combo.
computer and TV/DVD combo.
Image is not clear
•
Adjust the phase control.
Image is not centered
•
Adjust the horizontal control.
Picture has a few bright
or dark dots
or dark dots
•
A few bright or dark dots on an LCD screen are
normal. It does not affect the operation of your
TV/DVD combo.
normal. It does not affect the operation of your
TV/DVD combo.
Problem
Solution
No sound
•
Make sure that your TV/DVD combo or amplifier is
working correctly.
working correctly.
•
Make sure that the amplifier is set to receive DVD
signal input.
signal input.
No image
•
Make sure that your TV/DVD combo is working
correctly.
correctly.
•
Make sure that the color system is set correctly.
Bad sound quality
•
Make sure that the audio output mode is set correctly.
•
Make sure that the audio connection between your
TV/DVD combo and amplifier (if used) is secure.
TV/DVD combo and amplifier (if used) is secure.
Disc cannot be played
•
Make sure that the disc is inserted with the label
facing forward.
facing forward.
•
Clean the disc.
•
Moisture may have condensed in the DVD player.
Remove the disc and leave the player on for about an
hour to dry out.
Remove the disc and leave the player on for about an
hour to dry out.
The player does not
operate normally
operate normally
•
Disconnect the power plug, then reconnect it.
Remote control does
not work
not work
•
Remove obstacles between the remote control and
the player.
the player.
•
Point the remote control at your TV/DVD combo's
remote control sensor.
remote control sensor.
•
Install fresh batteries.
Problem
Solution