Руководство Пользователя для Xerox 6130

Specifies printer settings affecting jobs sent to the printer through a network port.

■

The settings in the Network Setup menu cannot be set when entering this menu during 
printing.

■

You need to restart the printer to activate the new settings. After making the settings, turn 
off the printer and then turn it on again.

Ethernet

Specifies the communication speed and the modes of Ethernet.

■

Auto (default)

 

Automatically changes between 10M Half Duplex, 10M Full Duplex, 100M 
Half Duplex, and 100M Full Duplex.

■

10M Half Duplex

■

10M Full Duplex

■

100M Half Duplex

■

100M Full Duplex

TCP/IP

Specifies the settings to use the TCP/IP protocol.

Get IP Address

Specifies whether to automatically or manually retrieve the IP address.

■

DHCP/Autonet (default)

 

Automatically sets the IP address.

■

 

Uses BOOTP to set the IP address automatically.

■

 

Uses RARP to set the IP address automatically.

■

 

Uses DHCP to set the IP address automatically.

■

 

You can set the IP address manually by entering it on the operator panel.

IP Address, 
Network Mask, 
Gateway 
Address

These items are used to check the addresses that have been obtained 
automatically or to specify addresses manually. Enter the address in the format 
of xxx.xxx.xxx.xxx. You can specifies values in the range of 0 to 255 for xxx.

■

To set addresses manually, set the Get IP Address to Panel.

■

IP addresses are managed in the entire network. An incorrect IP address 
may affect the whole network. For the addresses you need to set manually, 
contact your network administrator.