Справочник Пользователя для Xerox 6280
Managing the Printer
Phaser® 6280 Printer
148
Commands That Can Be Used in E-mail Text
Use each command according to the following rules.
•
Prefix all commands with “#”, and specify the #Password command at the top of the
e-mail.
e-mail.
•
Command lines without “#” are ignored.
•
Write one command on each line and separate each command and parameter with a
space or a tab.
space or a tab.
When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
subsequent commands are ignored.
Example of Commands
1. When the read only password is “ronly”, and to check the printer status:
#Password ronly
#Status
2. When the full access password is “admin”, and to set the recipient e-mail address to
“service@xerox.com”:
#Password admin
#SetMsgAddr service@xerox.com
3. When the full access password is “admin”, and to set the recipient e-mail address to
“service@xerox.com”, then confirm the setting result on the network settings list:
#Password admin
#SetMsgAddr service@xerox.com
#NetworkInfo
Note:
Describe the “#SetMsgAddr” command before the “#NetworkInfo” command. If
they are written in reverse, the information retrieved by the “#NetworkInfo” command
and the result of executing the “#SetMsgAddr” command may differ.
and the result of executing the “#SetMsgAddr” command may differ.
Command
Parameter
Description
#Password
Password
Use this command at the top of the e-mail when a password for
read only or full access is set. You can omit this command when
the password is not set.
read only or full access is set. You can omit this command when
the password is not set.
#NetworkInfo
Set this when you want to check information on the network
settings list.
settings list.
#Status
Set this when you want to check the printer status.
#SetMsgAddr
Recipient E-mail
address
address
Use this command to specify the e-mail address to which e-mail
reports are sent to. This command can only be used when the
full access password is specified by the #Password command.
reports are sent to. This command can only be used when the
full access password is specified by the #Password command.