Руководство Пользователя для Solis crema sl 90

3.4 Vent the appliance. To do this,
place a large container under the hot
water/steam jet and turn the rotary
switch  until a steady stream of water
comes out of the nozzle. Let it run
until about 2 dl of water has been
collected and then turn the rotary
switch off again. The appliance has
now been vented.

3.5 Rinse the appliance out. To do
this, fit the empty filter holder and
place a cup underneath. Turn the cof-
fee switch     on until the cup is full.
Turn the switch     off again. The appli-
ance has now been rinsed out. 

Note: If the coffee temperature light
remains red when the appliance is first
heated, no water can flow through the
filter holder. The appliance can only be
rinsed out when the green light comes
on. When the appliance has heated
up, the temperature light may change
from green to red. This is perfectly
normal and has no effect on the quali-
ty of the coffee.

3.6 The appliance is ready to ope-
rate when the temperature    light
shows green. We recommend lea-
ving the empty filter holder in place
while the appliance is heating up so
that it is pre-warmed.

3.1 Fill the water container with
cold water up to a maximum of 3 lit-
ers. Insert it into the rear of the appli-
ance and press home firmly so that
the base valve opens. Close the cover.

Note: Use only fresh cold water to fill
the container. Do not use mineral
water, milk or any other fluid.

3.2 Pull the required length of
cord out from the back of the
appliance. Leave the rest in the spe-
cial cable compartment. Connect the
appliance to an earthed socket.

3.3 Turn the main switch to ON.
The appliance must now be vented
and rinsed out.

Note: The best time to remove air
from the appliance is when it is cold.
For this reason, start the venting ope-
ration as quickly as possible after
switching on.

User’s manual