Инструкция С Настройками для ONKYO ht-s680

11

A

Speaker terminals
These push terminals are for connecting the speaker 
to the HT-R430 with the supplied speaker cables. 
The supplied speaker cables are color-coded for 
easy identification. Simply connect each cable to the 
same-colored positive speaker terminal.

B

Keyhole slots
These keyhole slots can be used to wall-mount the 
speaker. See page 19 for mounting instructions.

C

Speaker mount/bracket inserts
These threaded inserts can be used to attach the 
speaker to a speaker mount or bracket. See page 19 
for mounting instructions.

Note:
Use commercially available machine screws to 
attach the speaker to a speaker mount or bracket. 
North American models require 1/4-inch screws. 
Other models require M5 (5 mm) screws.

D

OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.

E

STANDBY/ON indicator
Red:

 Subwoofer in standby mode

Green:  Subwoofer on

With the Auto Standby function, the SKW-420 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for about 20 minutes, the SKW-420 automat-
ically enters Standby mode.

F

POWER switch (Not North American model) 
To turn on the SKW-420, set the POWER switch to 
the ON position (the indicator light up).
To turn off the SKW-420, set the POWER switch to 
the OFF position (the indicator goes out).

G

LINE INPUT
This RCA input should be connected to the SUB-
WOOFER PREOUT on your HT-R430 AV receiver, 
amp, or other receiver with supplied RCA cable.

Note:
The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
your receiver or amp (see page 47).

6

3

2

1

3

1

2

2

4 5

7

■ Rear

To AC outlet