Инструкция С Настройками для ONKYO HT-S990THX

 

33

 

With 

 (Remote Interactive), you can use the following special functions:

 

■

 

When you start playback on a component connected via 

, if the AV receiver is on Standby, it will automatically 

turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all compo-
nents connected via 

 will also go on Standby. This function will not work on components connected to an AC 

OUTLET on the AV receiver.

 

■

 

When playback is started on a component connected via 

, the AV receiver automatically selects that component 

as the input source. If your DVD player is connected to the AV receiver’s multichannel DVD input, you’ll need to 
press the [MULTI CH] button to hear all channels (see page 38), as the Direct Change 

 function only selects the 

FRONT DVD IN jacks.

 

■

 

You can use the AV receiver’s remote controller to control your other 

-capable Onkyo components, pointing the 

remote controller at the AV receiver’s remote control sensor instead of the component. You must enter the appropri-
ate remote control code first (page 58).

 

• Use only 

 cables for 

 connections. 

 

cables are supplied with Onkyo players (DVD, 
CD, etc.).

• Some components have two 

 jacks. You can 

connect either one to the AV receiver. The other 
jack is for connecting additional 

-capable 

components.

• Connect only Onkyo components to 

 jacks. 

Connecting other manufacturer’s components 
may cause a malfunction.

• Some components may not support all 

 func-

tions. Refer to the manuals supplied with your 
other Onkyo components.

• Connect the AV receiver’s and subwoofer’s power cord to a suitable wall outlet.

 

•

 

• Turning on the AV receiver and subwoofer may cause a momentary power surge that might interfere with other 

electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (con-

nection 

 in the hookup examples) (see pages 24 to 32).

Step 2: Make the 

 connection.

Step 3: If you’re using an MD, CDR, or HDD component, change the Input Display (see page 35).

HT-S990THX_En.book Page 33 Thursday, April 13, 2006 9:01 AM