Инструкция С Настройками для ONKYO TX-SR804

38

Connecting Your  Components—Continued

With 

 (Remote Interactive), you can use the following special functions:

When you start playback on a component connected via 

, if the AV receiver is on Standby, it will automatically turn 

on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components 
connected via 

 will also go on Standby. This function will not work with components connected to an AC OUTLET 

on the AV receiver.

When playback is started on a component connected via 

, the AV receiver automatically selects that component as 

the input source. If your DVD player is connected to the AV receiver’s multichannel DVD input, you’ll need to press 
the [MULTI CH] button to hear all channels (page 57), as the Direct Change 

 function only selects the FRONT jacks.

You can use the AV receiver’s remote controller to control your other 

-capable Onkyo components, pointing the 

remote controller at the AV receiver’s remote control sensor instead of the component. You must enter the appropriate 
remote control code first (see page 87).

• Use only 

 cables for 

 connections. 

 

cables are supplied with Onkyo players (DVD, 
CD, etc.).

• Some components have two 

 jacks. You can 

connect either one to the AV receiver. The other 
jack is for connecting additional 

-capable 

components.

• Connect only Onkyo components to 

 jacks. 

Connecting other manufacturer’s components 
may cause a malfunction.

• Some components may not support all 

 func-

tions. Refer to the manuals supplied with your 
other Onkyo components.

• Connect the AV receiver’s power cord to a suitable wall outlet.

• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment 

on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the 

 connection.

Step 3: If you’re using an MD, CDR, or HDD component, change the Input Display (see page 46).