Руководство Пользователя для Samsung CLP-600

vi

March 9, 1999: Council Directive 1999/5/EC on radio equipment and 

telecommunications terminal equipment and the mutual recognition of their conformity.
A full declaration, defining the relevant Directives and referenced standards can be 

obtained from your Samsung Electronics Co., Ltd. representative.

This Samsung product has been self-certified by Samsung for pan-European single 

terminal connection to the analogue public switched telephone network (PSTN) in 

accordance with Directive 1999/5/EC. The product has been designed to work with the 

national PSTNs and compatible PBXs of the European countries:
In the event of problems, you should contact the Euro QA Lab of Samsung Electronics 

Co., Ltd. in the first instance.
The product has been tested against TBR21 and/or TBR 38. To assist in the use and 

application of terminal equipment which complies with this standard, the European 

Telecommunication Standards Institute (ETSI) has issued an advisory document (EG 

201 121) which contains notes and additional requirements to ensure network 

compatibility of TBR21 terminals. The product has been designed against, and is fully 

compliant with, all of the relevant advisory notes contained in this document.

This Product is a printer; low power, Radio LAN type devices (radio frequency (RF) 

wireless communication devices), operating in the 2.4 GHz/5 GHz band, may be 

present (embedded) in your printer system which is intended for home or office use. This 

section is only applicable if these devices are present. Refer to the system label to verify 

the presence of wireless devices.
Wireless devices that may be in your system are only qualified for use in the European 

Union or associated areas if a CE mark with

 a Notified Body Registration Number 

and the Alert Symbol is on the system label.
The power output of the wireless device or devices that may be embedded in you printer 

is well below the RF exposure limits as set by the European Commission through the 

R&TTE directive.

Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, 

France (with frequency restrictions), Germany, Greece, Hungary, 

Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, The Netherlands, 

Poland, Portugal, Slovakia, Slovenia, Spain, Sweden and the U.K.

Iceland, Liechtenstein, Norway and Switzerland

In France, the frequency range is restricted to 2446.5-2483.5 MHz for 

devices above 10 mW transmitting power such as wireless

No limitations at this time.

Low power, Radio LAN type devices (radio frequency (RF) wireless communication 

devices), operating in the 2.4 GHz/5 GHz Band, may be present (embedded) in your 

printer system. The following section is a general overview of considerations while 

operating a wireless device.
Additional limitations, cautions, and concerns for specific countries are listed in the 

specific country sections (or country group sections). The wireless devices in your 

system are only qualified for use in the countries identified by the Radio Approval Marks 

on the system rating label. If the country you will be using the wireless device in, is not 

listed, please contact your local Radio Approval agency for requirements. Wireless 

devices are closely regulated and use may not be allowed.
The power output of the wireless device or devices that may be embedded in your 

printer is well below the RF exposure limits as known at this time. Because the wireless 

devices (which may be embedded into your printer) emit less energy than is allowed in 

radio frequency safety standards and recommendations, manufacturer believes these 

devices are safe for use. Regardless of the power levels, care should be taken to 

minimize human contact during normal operation.
As a general guideline, a separation of 20 cm (8 inches) between the wireless device 

and the body, for use of a wireless device near the body (this does not include 

extremities) is typical. This device should be used more than 20 cm (8 inches) from the 

body when wireless devices are on and transmitting.
This transmitter must not be collocated or operation in conjunction with any other 

antenna or transmitter.
Some circumstances require restrictions on wireless devices. Examples of common 

restrictions are listed below:

Radio frequency wireless communication can interfere with equipment 

on commercial aircraft. Current aviation regulations require wireless 

devices to be turned off while traveling in an airplane. IEEE 802.11 (also 

known as wireless Ethernet) and Bluetooth communication devices are 

examples of devices that provide wireless communication.
In environments where the risk of interference to other devices or 

services is harmful or perceived as harmful, the option to use a wireless 

device may be restricted or eliminated. Airports, Hospitals, and Oxygen 

or flammable gas laden atmospheres are limited examples where use 

of wireless devices may be restricted or eliminated. When in 

environments where you are uncertain of the sanction to use wireless 

devices, ask the applicable authority for authorization prior to use or 

turning on the wireless device.
Every country has different restrictions on the use of wireless devices. 

Since your system is equipped with a wireless device, when traveling 

between countries with your system, check with the local Radio 

Approval authorities prior to any move or trip for any restrictions on the 

use of a wireless device in the destination country.
If your system came equipped with an internal embedded wireless 

device, do not operate the wireless device unless all covers and shields 

are in place and the system is fully assembled.
Wireless devices are not user serviceable. Do not modify them in any 

way. Modification to a wireless device will void the authorization to use 

it. Please contact manufacturer for service.
Only use drivers approved for the country in which the device will be 

used. See the manufacturer System Restoration Kit, or contact 

manufacturer Technical Support for additional information.