Инструкции По Установке для Infocus lp630

 
 

q 

Raise the projector with the mounting bracket (B) and slip through the 
hinge pin slot openings on the bracket into the base box (H). Loosely 
install the two (2) hinge pin screws (L), conical spacers (J) and flat 
washers (K) and the angle locking screws (I). Adjust the angle and lock 
it. Then tighten the hinge pin screws (L).  Do not over tighten   
See Figure 3 

  

 
  
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 

 

 

Check all hardware for proper tighten and security. 

 

 

-_LA 073001_-

 

 

 
 
 
 
 

 

The ceiling should be capable of supporting a weight of 

at least five (5) times the projector(s) or monitor(s)weight. 

If it cannot, the ceiling must be reinforced. Proper 

installation procedure by qualified personnel as outlined 

in the installation instructions must be adhered to. 

Failure to do so could result in serious personal injury. 

 
 
 

To prevent eye injury wear protective eyewear before 

opening lamp door. 

 
 

 

A. 4 (mm) x 12 (mm) Knurl Knob (1ea) 
B. SP-CEIL-LM630 Mounting Bracket (1ea)  
C. 4 (mm) x 16 (mm) Phillip Screws (3ea)  
D. 4 (mm) Quick Release Sleeves (3ea) 
E. Projector  (not supplied) 
F. Ceiling Structure (See Warning Label)   
G. Suitable Hardware (Commercially Available) 
H. Base Box/Jam Screw (1ea) 
I.  6 (mm) x 12 (mm) Angle Locking Screws (2ea) 
J.  Conical Spacer (2ea) 
K. Flat Washers (2ea) 
L. 6 (mm) x 12 (mm) Hinge Pin Screws (2ea) 

         M.SP -LTMT-EXT Adjustable Suspesion Adapter (Optional)  

N. Suspension Adapter Ajustable Pins (2ea) 

 

 
 
 
 
 
 
 

 
 
 

 
 

 
 
 
 
 

 
 
 
 
 
 
 
 

 
 
 

 

 
 
                           
                                                    
 
 
 
 
 
 
 
 

 

 

 

 

 
 

 

  

27700B S.W. Parkway Ave. 

Wilsonville, Oregon 97070-9215 

Phone 1-800-294-6400  Fax

   

www.infocus.com

 

For further in formation or ordering assistance 

contact us at the phone/address number shown 

on the front of this page.