Руководство Пользователя для Pioneer pdp-4270hd
27
En
Preparation
05
English
2
With the Plasma Display lying flat, insert and secure the
two installation bolts
two installation bolts
➁ (M8 x 20 mm: black) in the holes
“a” located in center of the Plasma Display housing.
• At this point, tighten these bolts
➁ only until the threads
are no longer visible when viewed from the side (you will
be unable to attach the display if the bolts are screwed
in completely).
be unable to attach the display if the bolts are screwed
in completely).
• Make sure to remove the speaker mounting fittings.
NOTE
• When lying the Plasma Display down, be careful not to
scratch or damage it.
3
As shown in the above figure, hook the stand pipe holes
(pipe “B”) onto the screw heads of the installation bolts
(pipe “B”) onto the screw heads of the installation bolts
➁,
then slide the stand upwards to the main Plasma Display
until it engages the installation bolts
until it engages the installation bolts
➁ (once put together
with the display, the stand will slide no more than 19 mm
(3/4 inch)).
(3/4 inch)).
4
Pass the installation bolts
➀ (M8 x 40 mm: black) through
the stand pipes and tighten the installation bolts firmly
using the enclosed hexagonal wrench. (The holes should
be used in the proper combinations, “B” - “B”).
using the enclosed hexagonal wrench. (The holes should
be used in the proper combinations, “B” - “B”).
5
Tighten the installation bolts
➁ firmly using the enclosed
hexagonal wrench.
6
Replace the Plasma Display to stand upright.
• For speaker installation, see “Installing the PIONEER
NOTE
• Insert the bolts in the holes vertically and do not tighten them
with more force than necessary.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the Plasma Display lying flat on a table or
similar surface.
• Move the stand so that the stand screw holes and the nuts
that connect the main display line up correctly.
Installation
bolt
bolt
➁
Plasma Display
housing
housing
Stop screwing
down the bolt
when the
threads are no
longer visible.
down the bolt
when the
threads are no
longer visible.
Installation bolts
➁
(M8 x 20 mm: black)
Holes “a”
(holes in center of
Plasma Display)
(holes in center of
Plasma Display)
Plasma Display
Sheet
B
A
B
´
A
´
B
A
B
´
A
´
Installation bolts
➀
(M8 x 40 mm: black)
(Step 4)
(Step 4)
Table top stand
Slide the stand
(Step 3)
(Step 3)
PDP6070HD.book Page 27 Friday, May 19, 2006 5:01 PM