Руководство Пользователя для Spectra Logic nastape 100
Chapter 7. NAStape 200 Tape Drives and Media
54
Note:
If the cartridge ejects immediately, it has either expired or it is not
an approved cleaning cartridge. In this case, discard the cartridge
and begin the cleaning procedure with a new cartridge.
an approved cleaning cartridge. In this case, discard the cartridge
and begin the cleaning procedure with a new cartridge.
During the cleaning cycle, the amber Use Cleaning Cartridge LED will remain on
and the green Ready LED will flash.
and the green Ready LED will flash.
3.
The drive ejects the cartridge when complete; remove the cleaning cartridge
from the drive.
from the drive.
Caution:
Do not use the cleaning cartridge for more than the number of
specified cleaning cycles indicated on the cartridge label. Mark
the cleaning cartridge each time you use it or use backup
software to track cleaning cartridge usage.
specified cleaning cycles indicated on the cartridge label. Mark
the cleaning cartridge each time you use it or use backup
software to track cleaning cartridge usage.
Caring for HP Ultrium Media
Choosing Media
Use only LTO Ultrium cartridges. Compatible media is recognizable by the Ultrium
logo, which is the same as the logo on the front of the drive.
logo, which is the same as the logo on the front of the drive.
Caring for HP Ultrium Media
In optimal environments, LTO cartridges are should last for 1,000,000 passes over any
part of the tape (this equals approximately 2,000 complete backup and restore
operations). These numbers should, however, be limited in harsher environments.
part of the tape (this equals approximately 2,000 complete backup and restore
operations). These numbers should, however, be limited in harsher environments.
Caution:
If you are using bar code labels, make sure that only one label is
attached to the label area.
attached to the label area.
Never use non-standard labels, and never attach anything to the
cartridge other than in the label area.
cartridge other than in the label area.
Using HP Ultrium Media
Only use LTO Ultrium media within its operating range requirements (see Appendix A.
Specifications). If you expose the media to conditions that exceed these limits, stabilize
the media before use. To do this, keep the media out of use in the operating
environment for at least 24 hours.
Specifications). If you expose the media to conditions that exceed these limits, stabilize
the media before use. To do this, keep the media out of use in the operating
environment for at least 24 hours.