Инструкции Пользователя для LG LDE3019ST

ENGLISH

BEFORE CALLING FOR SERVICE

Before you call for service, review this list.It may save you time and expense. The list includes common

occurrences that are not the result of defective workmanship or materials in this appliance.

T RO U B L E S H O OT I N G

Problem

Range is not level.

Cannot move

appliance easily.

Appliance must be

accessible for

service.

Oven control beeps

and displays any F

code error.

Surface units will not

maintain a rolling boil

or cooking is not fast

enough

Surface units do not

work properly

Surface unit stops

glowing when

changed to a lower

setting

Areas of discoloration

on the cooktop

Frequent cycling on

and off of surface

units

• Poor installation.Place oven rack in center of oven. Place a level on the oven rack.

Adjust leveling legs at base of range until the oven rack is level.

• Be sure floor is level and strong and stable enough to adequately support range.

• If floor is sagging or sloping, contact a carpenter to correct the situation.

• Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are

square and have sufficient room for range clearance.

• Cabinets not square or are built in too tightly. Contact builder or installer to make

appliance accessible.

• Carpet interferes with range. Provide sufficient space so range can be lifted over

carpet.

• Anti-tip device engaged

• Electronic control has detected a fault condition.

Touch CLEAR OFF to clear the display and stop

beeping. Reprogram oven.

If fault recurs, record fault number. Touch

CLEAR OFF and contact a Service agent.

• Improper cookware being used.

- Use pans which are flat and match the diameter of the surface unit selected.

• In some areas, the power (voltage)may be low.

- Cover pan with a lid until desired heat is obtained.

• A fuse in your home may be blown or the circuit breaker tripped.

- Replace the fuse or reset the circuit breaker.

• Cooktop controls improperly set.

- Check to see the correct control is set for the surface unit you are using.

• This is normal. The unit is still on and hot.

• Food spillovers not cleaned before next use.

- See Cleaning the glass cooktop section.

• Hot surface on a model with a light-colored cooktop.

- This is normal. The surface may appear discolored when it is hot. This is

temporary and will disappear as the glass cools.

• This is normal.

- The element will cycle on and off to maintain the heat setting.

Possible Causes / Solutions

CODE

F-3

F-10

F-11

Shorted keypad

Door locking system

don't operate

No heating

CAUSE