Справочник Пользователя для Cisco 2600 Enterprise Plus Feature Pack CD26-AP-12.0.7=

Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers  19

The following example shows how to use the copy xmodem flash command on a Cisco 2600 series
router.

Router# copy xmodem flash

                               **** WARNING ****

       x/ymodem is a slow transfer protocol limited to the current speed

       settings of the auxiliary/console ports. The use of the auxiliary

       port for this download is strongly recommended.

       During the course of the download no exec input/output will be

       available.

                               ---- ******* ----

       Proceed? [confirm] yes

       Use crc block checksumming? [confirm] yes

       Max Retry Count [10]:

       Perform image validation checks? [confirm] yes

       Xmodem download using crc checksumming with image validation

       Continue? [confirm] yes

       Partition   Size    Used      Free      Bank-Size  State          Copy Mode

         1         4096K   3259K      836K     4096K      Read/Write     Direct

         2         4096K      0K     4095K     4096K      Read/Write     Direct

       [Type ?<no> for partition directory; ? for full directory; q to abort]

       Which partition? [default = 1] 2

       System flash directory, partition 2:

       File  Length   Name/status

         1   68       TESTFILE

       [132 bytes used, 4194172 available, 4194304 total]

       Destination file name? c3620-i-mz.0918

       Erase flash device before writing? [confirm] yes

       Flash contains files. Are you sure you want to erase? [confirm]y

       Copy '' from server

         as 'c3620-i-mz.0918' into Flash WITH erase? [yes/no] yes

       Erasing device... eeeeeeeeeeeeeeee ...erased

       Ready to receive file...........C

       Verifying checksum...  OK (0x5DE8)

       Flash device copy took 00:12:06 [hh:mm:ss]

Installing the Router Software Using a TFTP Server Application

Use this TFTP server application method as an alternative to using the RSL to install the router
software from the CD-ROM. You can perform this procedure using a PC (running Microsoft
Windows 95 or Microsoft Windows 3.1), a Macintosh, or a UNIX system. You can use either the
copy tftp flash or copy rcp flash command to download the router software to the router.

First, obtain a TFTP application or a remote copy protocol (rcp) application to set up your computer
as a TFTP server or a rcp server. Only use the RSL or the TFTP server included on the feature pack
CD-ROM to install the router software if you are using a PC running Windows 95. For other
operating systems, a number of TFTP or rcp applications are available from independent software
vendors or available as shareware from public sources on the World Wide Web.