Инструкция для Sony SLV-N50
Getti
ng Sta
rted
9
Hookups
Completing A/V hookup:
After you’ve connected your TV and completed antenna or cable hookup, return to
this procedure to complete VCR set up. This will prevent unwanted noise in the RF
channel.
this procedure to complete VCR set up. This will prevent unwanted noise in the RF
channel.
Caution
Connections between the VCR’s VHF/UHF connector and the antenna terminals of the TV
receiver should be made only as shown in the following instructions. Failure to do so may result
in operation that violates the regulations of the Federal Communications Commission regarding
the use and operation of RF devices. Never connect the output of the VCR to an antenna or
make simultaneous (parallel) antenna and VCR connections at the antenna terminals of your
receiver.
receiver should be made only as shown in the following instructions. Failure to do so may result
in operation that violates the regulations of the Federal Communications Commission regarding
the use and operation of RF devices. Never connect the output of the VCR to an antenna or
make simultaneous (parallel) antenna and VCR connections at the antenna terminals of your
receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer’s attention to Article 820- 40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
SET
:
SELECT :
OK
MENU
MENU
QUIT
:
TIMER SET/CHECK
SETTINGS
ADVANCED OPTIONS
SET
:
SELECT :
OK
MENU
MENU
QUIT
:
ADVANCED OPTIONS
AUTO STEREO
AUTO ANT SELECT
TUNER AUDIO
APC
TAPE SELECT
APC
TAPE SELECT
OFF
ON
ON
AUTO
AUTO
AUTO TAPE SPEED
ON
ON
ON
SHARPNESS
L
H
RETURN
FAVORITE CH
Press MENU and select
ADVANCED OPTIONS.
ADVANCED OPTIONS.
Set AUTO ANT SELECT
to OFF and press OK.
to OFF and press OK.
For details, see page 68.
,