Справочник Пользователя для D-Link DCS-960L

This section allows you to configure your camera to send snapshots and video clips to an e-mail address. You can set the camera to send snapshots 

and video clips to different e-mail addresses. If you are not sure what settings to use, check with your e-mail service provider.

This is the domain name or IP address of your external e-mail server.

This is the port used by your external e-mail server.

This is the e-mail address listed as the sender for your notification e-mails.

This is the e-mail address that your notification e-mails will be sent to.

If the SMTP server uses authentication, enter your user name.

If the SMTP server uses authentication, enter your password.

Enter the amount of time to wait before the camera can send another e-mail.

If your SMTP server requires SSL-TLS or STARTTLS, select it here.

For example, if you want to use Gmail with SSL-TLS for e-mail notifications, you 

can follow the setup procedure as below:

Step 1 - Enter “smtp.gmail.com” in SMTP Server Address.

Step 2 - Change the SMTP server port number from 25 to 465.

Step 3 - Enter your gmail e-mail address in Sender E-mail Address.

Step 4 - Enter the destination e-mail address in Receiver E-mail Address.

Step 5 - Enter the user name required to access the SMTP server.

Step 6 - Enter the password required to access the SMTP server.

Step 7 - Select SSL-TLS and then click Save Settings.

Step 8 - Click the Test button to send a test e-mail will be sent.

Note: You can also use STARTTLS, which will use SMTP server port number 587. 

If you want to use a Yahoo SMTP server, the SMTP server address will be different 

for each registered region, and only SMTP port 465 is supported for SSL-TLS.