Использование И Уход для KitchenAid 15'' Automatic Ice Maker

NOTE: Do not kink, smash or damage tubes or wires during 
installation.

1. Unplug ice maker or disconnect power.

2. Remove rear panel. See “Rear Panel” illustration for 5 screw

locations. Pull rear panel away from the drain tube and
discard.

3. Remove the old drain tube and clamp attached to the ice

maker bin.

NOTE: Discard old drain tube and clamp.

4. Install new drain tube (

⁵⁄₈" ID x 5¹⁄₈") from ice maker bin to

drain pump reservoir inlet using new adjustable clamps. See
“Drain Tube” illustration.

■

Do not kink.

■

Trim tube length, if required.

5. Install vent tube (

⁵⁄₁₆" ID x 32" [81 cm]) to drain pump reservoir

vent. Use one 

⁵⁄₈" small adjustable clamp, supplied. See

“Parts Locations” illustration.

NOTE: Do not install household drain tube at this time.

6. Remove power cord clamp and ground screw attached to ice 

maker power cord which is mounted to the unit base. See

 

“Parts Locations” illustration.
NOTE: 

Clamp and screw will be reused.

7. Slide drain pump into the ice maker base on the right side. 

The pump mounting tab should slip into the rectangular slot

 

in the ice maker base. It will be necessary to tip the pump

 

slightly to slip into the slot. See “Drain Pump Mounting Tab

 

Slot” illustration. 

⁷⁄₈

⁷⁄₈

A

A

A

B

C

D

⁵⁄₈

³⁄₈

A

B

C
D

E

F

G

A