Руководство По Установке для KitchenAid KXD4630YSS

NOTE: Your downdraft vent requires you to purchase an  

in-line (external type) blower motor system. See “Blower  

Motor System” in the “Accessories” section.

The in-line blower system must be fastened to a secure 

structure of the roof, ceiling, wall, floor, or new or existing frame 

construction. The 4 holes on either the inlet (bottom) side or the 

outlet (top) side of the blower must be used to mount the in-line 

blower system to the structure.
NOTE: The mounting hole locations must span the studs. 

Additional stud framing may be required. Plywood may be  

used to span open areas between ceiling or floor joists or roof 

rafters to aid installation. This structure must be strong enough 

to support the weight of the in-line blower system (50 lb  

[22.6 kg] min).

1.  Using 2 or more people, move the in-line blower motor 

system to the mounting location.

2.  Remove the 10 screws from the front cover of the in-line 

blower motor housing and set them aside.

3.  Remove the front cover of the in-line blower motor housing 

and set it aside.
NOTE: To make the blower motor housing easier to mount, 

the blower motor assembly can be removed. If you do not 

want to remove the blower motor assembly, proceed to 

“Install In-line Blower System” in this section.

4.  Disconnect the motor electrical plug from the blower motor 

assembly.

5.  Remove the screws that secure the blower motor assembly 

to the in-line blower housing and set them aside.

6.  Pull the spring clip to release the blower motor assembly. 

Remove the blower motor assembly from the housing and 

place it on a covered surface.

NOTE: The blower motor housing can be mounted using 4 holes 

from either the inlet side or the outlet side of the blower.

1.  Position the in-line blower motor housing in its mounting 

location and mark the 4 mounting hole locations.

2.  Drill 4 mounting pilot holes using a 

3

/

16

" (4.8 mm) drill bit.

3.  Attach the in-line blower motor housing to the mounting 

location with four 6 x 80 mm mounting screws and washers.

4.  If it is removed, reinstall the blower motor assembly and 

secure it with the screws previously removed.

5.  If it is removed, reattach the motor electrical plug to the 

connector on the blower motor assembly.

1.  Determine and make all necessary cuts for the vent system.

IMPORTANT: When cutting or drilling into the floor, ceiling or 

wall, do not damage electrical wiring or other hidden utilities.

2.  Determine the location where the 

1

/

2

" (1.3 cm) wiring conduit 

will be routed through the floor, ceiling or wall between the 

inline blower and the downdraft vent.

3.  Drill a 1

1

/

4

" (3.2 cm) hole at this location.

Install Downdraft Vent In-Line (External Type) Blower Motor