Инструкция для Canon imageFORMULA P-215II
106
3
Remove the jammed document from the feed side or eject side.
4
Close the feeder cover.
After you remove the jammed paper, check to see if the last page was
scanned correctly, and then continue scanning.
scanned correctly, and then continue scanning.
Clearing a Card Jam
If a card is inserted into the slot at an angle, the card may jam during
scanning.
scanning.
If a card jam occurs, try pulling the card out, or open the feeder cover to
remove the card.
remove the card.
When opening the feeder cover to remove a jammed card, open the cover
slowly. Opening the feeder cover too wide will put pressure on the card
and may damage it.
slowly. Opening the feeder cover too wide will put pressure on the card
and may damage it.
Carefully pull out the document without using excessive force. If the
jammed paper tears, make sure that you remove any remaining pieces.
jammed paper tears, make sure that you remove any remaining pieces.
Make sure the document does not get caught in the card guides as well.
When a paper jam or other problem occurs while [Rapid recovery
system] is enabled in the scanner driver, the image of the last
document that was scanned properly is saved before scanning is
stopped. Therefore, you can quickly resume scanning after
resolving the cause of the interruption. As the image of the
document that was being fed at the time of the interruption may not
be saved in such cases, be sure to verify the last scanned image
before resuming the operation.
system] is enabled in the scanner driver, the image of the last
document that was scanned properly is saved before scanning is
stopped. Therefore, you can quickly resume scanning after
resolving the cause of the interruption. As the image of the
document that was being fed at the time of the interruption may not
be saved in such cases, be sure to verify the last scanned image
before resuming the operation.