Инструкция для Canon Wireless File Transmitter WFT-E4 II A

78

Connecting External Media

Before unplugging external media from the USB port, always select [Disconnect] as shown in 
step 5. Follow the instructions displayed to terminate the connection.

The connection will not be terminated if you simply turn off the camera and external media. If 
you unplug external media while the connection is still active, plug the external media into the 
USB port again and follow the preceding steps to terminate the connection.

External media is powered via the transmitter’s USB port as needed. However, external hard 
disk drives may not work after connection in some cases.

 

If you will not use a wireless or wired LAN at the 
same time as the external media, set 
[Communication mode] to [Disconnect]. The 
battery drains faster under settings other than 
[Disconnect] because power saving is disabled.

 

Setting [Power saving] to [Enable] enables the 
power supply to external media to be stopped 
automatically, conserving the battery. Power is 
supplied again automatically during shooting, 
when captured images are stored.

Before shooting movie, set [Power saving] to [Disable] and make sure the transmitter’s <USB> lamp 
is lit in green. If you start shooting movie when the <USB> lamp is out or blinking, the movie may not be 
recorded to external media. 

COP

Y