Инструкция С Настройками для Canon EOS-1D Mark II N
176
If there is a problem, first refer to this Troubleshooting Guide.
You are using the wrong battery.
X
Use the dedicated Ni-MH Pack. (p.22)
The battery is not properly attached to the charger.
X
Attach the battery properly to the charger. (p.22)
The battery is exhausted.
X
Recharge the battery. (p.22)
The battery is not installed properly.
X
Install the battery properly. (p.25)
The memory card slot is open.
X
Push in the memory card and close the memory card slot. (p.30)
If you set the <
4
> switch to <
2
> right after shooting, the
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
image is recorded onto the memory card.
X
When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
card, the access lamp will stop blinking and the power will turn off.
The battery is not fully charged.
X
Recharge the battery fully. (p.22)
The battery’s service life has expired.
X
Replace it with a new battery. (p.182)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the <4> switch is set to <1>.
The access lamp lights or blinks even when the <4> switch is set to <2>.
The battery becomes exhausted quickly.