Инструкция для Canon VB-H610VE

94

[Wide-angle]: Wide-angle limit of the view restriction. 

Click [Get value] to load the zoom 

ratio of the current camera angle.

(11)[Display in panorama screen] 

Apply the current view restriction settings to the 

panorama screen. At this point, the settings are not 

yet saved in the camera. Be sure to click [Save 

settings]. 

(12)[Restore settings] 

Clear the settings you have specified on the screen of 

the tool and restore the settings saved in the camera. 

(13)[Save settings] 

Save the set view restriction in the camera. 

After the view restriction has been set, be sure to save 

the settings in the camera by clicking [Save settings].

You can set view restrictions by entering values in the 

view restriction setting entry boxes, or by changing the 

current settings in the view restriction preview frame of the 

panorama screen or from the camera angle in the image 

display area. Select appropriate settings according to the 

environment in which the camera is operated or the 

purpose for which it is used.

„ Use the preview frame on the panorama 

When the telephoto/wide-angle preview frames are 

enlarged/shrunk, the aspect ratio remains the same. 

At this time, you can also enter view restrictions by 

entering values in the view restriction setting entry 

boxes. If you have adjusted the view restriction 

settings, click [Display in panorama screen]. The 

settings are reflected in the preview frame of the 

panorama screen. 

Confirm that the settings have been applied correctly, 

and then click [Save settings] to save the settings in 

the camera.

„ Setting by Loading Position Information from 

The loaded view restriction can be checked in the 

view restriction setting entry box or view restriction 

preview frame. 

The settings are saved in the camera. 

• Even when view restrictions are set, an area outside the view 

restriction may still appear momentarily when the camera is 
controlled near the boundary of the view restriction. 

• To cancel the view restrictions, clear the [Apply the view 

restriction] checkbox and then click [Save settings].

• If the setting fields are cleared while the [Apply the view 

restriction] checkbox is selected, the maximum view restriction 

will be set.

• The controllable range and range that can be captured are as 

follows. 

Select the [Apply the view restriction] checkbox. 

Drag to change the [Pan/tilt preview frame (red 

frame)], [Telephoto preview frame (yellow frame)], or 
[Wide-angle preview frame (green frame)] shown on 
the panorama screen to set view restrictions.

Click [Save settings].

Select the [Apply the view restriction] checkbox. 

Click the [Obtain/Release Camera Control] button to 
obtain the control privileges of the camera. 

Operate the camera to adjust the top edge, bottom 

edge, left edge, right edge, telephoto, or wide angle to 
desired positions, and click [Get value] each time.

Click [Save settings].

• If you have changed the camera mounting method, 

recapture the panorama image and register it again. 

• The panorama screen may be slightly different from the 

actual image. After view restrictions have been set, be sure 
to confirm with the VB Viewer that the view restrictions have 

been reflected correctly. 

• Confirm the settings using the VB Viewer. (View restrictions 

are not applied to the image display area of this tool, nor to 

the Admin Viewer.)

• If the image stabilizer or digital zoom setting has been 

changed, check the view restriction settings again.