Справочник Пользователя для ASUS Z9PR-D16

ASUS Z9PR-D16

2-17

To install an expansion card:
1.  Before installing the expansion card, read the documentation that came with 

it and make the necessary hardware settings for the card.

2.  Remove the system unit cover (if your motherboard is already installed in a 

chassis).

3.  Remove the bracket opposite the slot that you intend to use. Keep the screw 

for later use.

4.  Align the card connector with the slot and press firmly until the card is 

completely seated on the slot.

5.  Secure the card to the chassis with the screw you removed earlier.
6.  Replace the system cover.

After installing the expansion card, configure it by adjusting the software settings.
1.  Turn on the system and change the necessary BIOS settings, if any. See 

Chapter 4 for information on BIOS setup.

2.  Assign an IRQ to the card. Refer to the tables on the next page.
3.  Install the software drivers for the expansion card.

Unplug the power cord before adding or removing expansion cards. Failure to 

do so may cause you physical injury and damage motherboard components.

When using PCI cards on shared slots, ensure that the drivers support “Share 

IRQ” or that the cards do not need IRQ assignments. Otherwise, conflicts will 

arise between the two PCI groups, resulting to an unstable system and an 

inoperable card.