Справочник Пользователя для ASUS ESC8000 G3

ASUS ESC8000 G3

6-3

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA 

hard disk drives attached to the SATA connectors supported by 

Intel

®

C610 chipset. To do this:

1.

Enter the BIOS Setup during POST.

2.

Go to the Advanced Menu > PCH SATA Configuration, then press <Enter>.

3.

Set SATA Mode to [RAID Mode]

4.

Press <F10> to save your changes and exit the BIOS Setup.

Refer to Chapter 5 for details on entering and navigating through the BIOS Setup.

Depending on the RAID connectors that you use, you can create a RAID set using the utilities

embedded in each RAID controller. For example, use the LSI Logic Embedded SATA RAID

Setup Utility or the Intel

®

Rapid Storage Technology if you installed Serial ATA hard disk

drives on the Serial ATA connectors supported by the Intel

®

C610 chipset.

Refer to the succeeding section for details on how to use the RAID configuration utility.

The motherboard supports Serial ATA for RAID set configuration. For optimal performance,

install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:

1.

Install the SATA hard disks into the drive bays following the instructions in the system

user guide.

2.

Connect a SATA signal cable to the signal connector at the back of each drive and to

the SATA connector on the motherboard.

3.

Connect a SATA power cable to the power connector on each drive.