Инструкция для Canon imagePROGRAF iPF850 MFP M40
Roll paper cannot be inserted into the Paper Feed Slot
Roll paper cannot be inserted into the Paper Feed Slot
Cause
Corrective Action
The roll paper is warped.
Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot.
Remove the jammed paper.
The paper source selection is incorrect.
Press the Load button and select the paper source.
If paper cannot be advanced from Roll 2 (Lower),
the Roll Unit Cable is disconnected.
the Roll Unit Cable is disconnected.
Connect the Roll Unit Cable firmly to the Roll Unit Power Supply Inlet and the
inlet on the roll unit.
inlet on the roll unit.
Cannot load sheets
Cannot load sheets
Cause
Corrective Action
The paper source selection is incorrect.
Press the Load button and select the paper source.
Paper is not cut neatly
Paper is not cut neatly
Cause
Corrective Action
The paper is bent or curled at the cut posi-
tion.
tion.
Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position
before it is cut.
before it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with
the Cutter Unit.
the Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
➔
User's Guide
Cut Speed is not configured correctly in the
Control Panel menu.
Control Panel menu.
Change the Cut Speed setting in the Control Panel menu.
During cutting, printed documents fall out at
an angle.
an angle.
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
ing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
➔
User's Guide
Paper is not cut
Paper is not cut
Cause
Corrective Action
In the printer driver, No or Print Cut Guideline is specified
in Automatic Cutting.
in Automatic Cutting.
Specify Yes in Automatic Cutting in the printer driver.
(See "Page Setup Sheet (Windows).")
➔
User's Guide
(See "Paper Detailed Settings Dialog Box (Mac OS).")
➔
User's Guide
In the Control Panel menu, Cutting Mode is set to Eject
or Manual.
or Manual.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
(See "Specifying the Cutting Method for Rolls.")
➔
User's Guide
The Stacker continues to rotate
The Stacker continues to rotate
Cause
Corrective Action
The paper is not fed into the Stacker from the printer because of a paper jam, etc.
Turn the Stacker power switch off.
The size of clear film cannot be detected
The size of clear film cannot be detected
Cause
Corrective Action
The Platen is soiled with ink or other substances.
Open the Top Cover and clean the entire Platen.
Roll paper cannot be inserted into the Paper Feed Slot
iPF850 Series
Troubleshooting
Problems Regarding Paper
122