Инструкция для Canon imagePROGRAF iPF785 MFP M40
Cause
Corrective Action
The loaded paper is too small.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll Holder from Rolls.")
➔
User's Guide
2.
Replace the roll with a roll 10 inches wide or larger.
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
"Remove paper and check pap. size"
Cause
Corrective Action
A sheet has come out of the printer during printing.
1.
Press the Release Lever back and remove the paper.
2.
Reload the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown
on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error occur-
red.
on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error occur-
red.
PaprWidth Mismatch
PaprWidth Mismatch
Cause
Corrective Action
When Detect Mismatch in the Control Panel
menu is set to Pause or Hold Job, the width of the
loaded roll does not match the width specified in
Fit Roll Paper Width in the printer driver.
menu is set to Pause or Hold Job, the width of the
loaded roll does not match the width specified in
Fit Roll Paper Width in the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume print-
ing.
However, note that this error may cause paper jams and affect the printing
quality.
ing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll Holder from Rolls.")
➔
User's Guide
2.
Replace with paper of the width configured in the printer driver.
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause
Corrective Action
Paper has been loaded
askew, or warped paper
has been loaded.
askew, or warped paper
has been loaded.
Follow these steps to reload the roll.
1.
Press the OK button and reload the paper.
iPF785 Series
PaprWidth Mismatch
Error Message
Messages regarding paper
115