Инструкция для Canon imagePROGRAF iPF9400
Note
•
We recommend executing the adjustment if you have changed the paper type or paper size.
•
Always check the Adj. Priority values before using Manual adjustment.
•
If additional fine-tuning is necessary after Manual adjustment, use Adj. Fine Feed
•
Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.
Paper to Prepare
When Using Rolls
An unused roll at least 254.0 mm (10.00 in) wide
When Using Sheets Two sheets of unused paper of at least A4/Letter size
Perform adjustment as follows.
1
Load the paper.
•
•
•
Important
•
Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be completed correctly
unless the loaded paper matches the settings.
unless the loaded paper matches the settings.
2
On the Tab Selection screen of the Control Panel, press
◀ or ▶ to se-
lect the Settings/Adj. tab (
).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
The Set./Adj. Menu is displayed.
4
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
5
Press ▲ or ▼ to select Feed Priority, and then press the OK button.
6
Press ▲ or ▼ to select Adj. Quality, and then press the OK button.
7
Press ▲ or ▼ to select Manual, and then press the OK button.
Test pattern A is printed for manual adjustment.
Test pattern A is printed for manual adjustment.
Note
•
When printing on sheets, follow the instructions on the Display Screen and remove the sheet.
Manual Banding Adjustment
iPF9400
Adjustments for Better Print Quality
Adjusting the feed amount
808