Инструкция для Canon imagePROGRAF iPF830 MFP M40

 

Insert the Holder Stopper from the left in the Roll Holder as
shown. Holding it at the position shown (b), push it firmly in
until the flange (a) of the Holder Stopper touches the roll.
Lock the Holder Stopper lever (c) by pushing it down to-
ward the shaft side.

Follow these steps to load rolls in the printer.

Important

Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be advanced
correctly when you turn the printer on.

Before loading a roll, confirm whether the inside of the Top Cover or the Ejection Guide is soiled. If soiled, we
recommend cleaning in advance.  (See "

 

Press the Load button.

Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button.

Note

If any roll paper that will not be used or cut sheet has been fed, a message is shown requesting you to
remove it.
Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.

If roll paper is loaded but cut sheet is selected as the paper source, a message asking you whether or not
to change paper is displayed.
Press ▲ or ▼ to select Load, and then press the OK button. Remove the paper and proceed to the next
step.

a

c

b

 

 

iPF830

                                                                                                                                                                                      

Loading Rolls in the Printer

                                                                                                                                                                                                                      

Handling and Use of Paper

Handling rolls

333