Инструкция для Canon imagePROGRAF iPF830 MFP M40
7
Print the job.
When printing is finished, the printer will stop without cutting.
When printing is finished, the printer will stop without cutting.
8
Holding the printed document to prevent it from dropping,
press the Cut button to cut the roll.
press the Cut button to cut the roll.
Manual (when using media that cannot be cut with the Cutter Unit )
Rewind paper by pressing
the
OK button
Feed paper to the cut
position by pressing the
Feed button and cut
manually
Print
Select
Manual
Manual
Rose Wine
Rose
Wine
Note
•
Once the following step has been performed, the procedure can be started from step 8 the next time.
•
Printing the second and subsequent times
•
Printing after replacing with the same type of paper
1
On the Tab Selection screen of the Control Panel, press
◀ or ▶ to
select the Paper tab (
).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6
Press ▲ or ▼ to select Manual, and then press the OK button.
7
When "Perform the detection of paper leading edge?" is displayed, select Perform(recommend).
8
Print the job.
The printer stops advancing the paper after printing.
The printer stops advancing the paper after printing.
Specifying the Cutting Method for Rolls
iPF830
Handling and Use of Paper
Handling rolls
346