Инструкция для Canon imagePROGRAF iPF8400
Cause
Corrective Action
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.
cannot be detected.
Open the Top Cover and clean the entire
Platen.
Platen.
Insufficient paper for job
Insufficient paper for job
Cause
Corrective Action
The printer has received a print job longer than the amount of roll paper left when Man-
ageRemainRoll in the Control Panel menu is On.
ageRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during
the print job and you may not be able to print
all of the document.
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during
the print job and you may not be able to print
all of the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driv-
er, or replace the roll with a roll that has
enough paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then
try printing again.
then press the OK button.
Change the Paper Source of the printer driv-
er, or replace the roll with a roll that has
enough paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then
try printing again.
(See "Removing Printed Documents from the
Media Take-up Unit (Optional).")
Media Take-up Unit (Optional).")
→
User's Guide
Press ▲ or ▼ to select Stop Printing or
press the Stop button to stop printing.
press the Stop button to stop printing.
This paper cannot be used as size is not supported.
This paper cannot be used as size is not supported.
Cause
Corrective Action
Paper that is too large for the printer has been loa-
ded.
ded.
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
→
User's Guide
iPF8400
Insufficient paper for job
Error Message
Messages regarding paper
135