Инструкция для Canon imagePROGRAF iPF6400S
iPF6400S Basic Guide
110
Tro
ubl
esho
ubl
esho
otin
g
g
P
rob
lem
s Reg
lem
s Reg
ard
ing Pap
er
Cause
Corrective Action
without printing on it may leave a depression
on the leading edge.
on the leading edge.
TrimEdge Reload to On or Automatic so that the paper edge is
automatically cut before printing.
(See "Menu Structure.")➔P.66
automatically cut before printing.
(See "Menu Structure.")➔P.66
Margins are wide
Cause
Corrective Action
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
prevent problems with cutting and paper ejection.
This operation is normal.
When Cutting Mode in the Control Panel menu was set to
Manual, you selected Do not perform in response to the
Perform the detection of paper leading edge? message.
Manual, you selected Do not perform in response to the
Perform the detection of paper leading edge? message.
Set Cutting Mode to Manual again, and select
Perform(recommend) when the Perform the detection of
paper leading edge? message is displayed.
Note that when you select Perform(recommend), if the
paper is strongly curled, the Printhead may rub against the
leading edge of the paper when the printing starts.
(See "Specifying the Cutting Method for Rolls.")➔User's
Guide
Perform(recommend) when the Perform the detection of
paper leading edge? message is displayed.
Note that when you select Perform(recommend), if the
paper is strongly curled, the Printhead may rub against the
leading edge of the paper when the printing starts.
(See "Specifying the Cutting Method for Rolls.")➔User's
Guide