Инструкция для Canon imagePROGRAF iPF6400S
Cut sheets cannot be pulled out from the front paper feed slot
Cut sheets cannot be pulled out from the front paper feed slot
Cause
Corrective Action
You have loaded
paper other than
POP board.
paper other than
POP board.
Push the cut sheet from the front side of the printer towards the back side. Once the edge of the cut sheet protrudes
from the back side of the printer, pull it out from the back side.
from the back side of the printer, pull it out from the back side.
Roll paper cannot be inserted into the paper feed slot
Roll paper cannot be inserted into the paper feed slot
Cause
Corrective Action
The roll paper is warped.
Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot.
Remove the jammed paper.
After a roll was advanced, the paper was manually pulled out by force, clos-
ing the Paper Feed Slot.
ing the Paper Feed Slot.
Remove the roll and open the paper feed slot.
Cannot load sheets
Cannot load sheets
Cause
Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly
Paper is not cut neatly
Cause
Corrective Action
The paper is bent or curled at the cut position.
Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position before
it is cut.
it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with the
Cutter Unit.
Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
cutting tool to cut the roll after printing.
Cut Speed is not configured correctly in the Con-
trol Panel menu.
trol Panel menu.
Change the Cut Speed setting in the Control Panel menu.
During cutting, printed documents fall out at an
angle.
angle.
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
ing, as they are cut.
Paper is not cut
Paper is not cut
Cause
Corrective Action
The printed document became caught on a foreign object by the
Output Tray, which lifted the document. The Cutter passed un-
der the paper.
Output Tray, which lifted the document. The Cutter passed un-
der the paper.
Remove the foreign object by the Output Tray to enable the printer to
eject the printed document, keeping it level.
eject the printed document, keeping it level.
In the printer driver, No or Print Cut Guideline is specified in
Automatic Cutting.
Automatic Cutting.
Specify Yes in Automatic Cutting in the printer driver.
Cut sheets cannot be pulled out from the front paper feed slot
iPF6400S
Troubleshooting
Problems Regarding Paper
950