Инструкция для Canon imagePROGRAF iPF9400S
"Replace roll with 10 in. wide or larger roll."
Cause
Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or other
printer status information.)
(When you have attempted to print a test print sheet or other
printer status information.)
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll Holder from Rolls.")
→User's Guide
2.
Replace the roll with a roll 10 inches wide or larger.
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch
PaprWidth Mismatch
Cause
Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing
quality.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing Rolls From the Roll Holder.")
→User's Guide
2.
Replace with paper of the width configured in the printer driver.
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded in
the printer, and then try printing again.
Fit Roll Paper Width in the printer driver matches the width of the roll loaded in
the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause
Corrective Action
Paper has been loaded askew, or warped paper has been loaded.
Lift up the Release Lever and reload the pa-
per.
per.
If "Not finished printing. Finish printing
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
iPF9400S
PaprWidth Mismatch
Error Message
Messages regarding paper
131