Инструкция для Canon PowerShot N100 White

33

If the camera is turned on while the <

p> button is held down, the 

camera will no longer sound. To activate sounds again, press the 
<

n> button and choose [Mute] on the [3] tab, and then press 

the <

q><r> buttons to choose [Off].

A blinking [

] icon warns that images are more likely to be blurred 

by camera shake. In this case, mount the camera on a tripod or take 
other measures to keep it still.

If your shots are dark despite the flash firing, move closer to the 

The subject may be too close if the camera only beeps once when 
you press the shutter button halfway. For details on the focusing 
range (shooting range), see “Shooting Range” (

To reduce red-eye and to assist in focusing, the lamp may be 
activated when shooting in low-light conditions.

A blinking [

h] icon displayed when you attempt to shoot indicates 

that shooting is not possible until the flash has finished recharging. 

Shooting can resume as soon as the flash is ready, so either press 
the shutter button all the way down and wait, or release it and press 
it again.

The shutter sound will not be played when the Sleeping and Babies 
(Sleeping) icons (

Although you can shoot again before the shooting screen is 
displayed, your previous shot may determine the focus, brightness, 
and colors used.

You can change how long images are displayed after shots (

).

The camera may become warm when shooting movies repeatedly 
over an extended period. This does not indicate damage.

Keep your fingers away from the 
microphone while shooting movies. 
Blocking the microphone may prevent 
audio from being recorded or may 

cause the recording to sound muffled.

Avoid touching camera controls other than the movie button when 
shooting movies, because sounds made by the camera will be 
recorded.

Once movie recording begins, the image display area changes and 

subjects are enlarged to allow for correction of significant camera 
shake. To shoot subjects at the same size shown before shooting, 
adjust the image stabilization setting (

).

Audio is recorded in stereo.

Distorted audio caused by recording when the wind is strong can be reduced. 
However, the recording may sound unnatural when this option is used when 
there is no wind. When the wind is not strong, choose MENU (

) > [

4] 

tab > [Wind Filter] > [Off] (

Microphone