Инструкция С Настройками для Olympus E-410

42 

EN

Shooting functions 

k

 Various shooting functions

Super FP flash is available with the FL-50 or FL-36. 
Use the Super FP flash where normal flashes cannot 
be used with high shutter speed.
Fill-in flash shooting with the aperture open (such as in 
outdoor portrait shooting) is also possible with Super 
FP flash. For details, refer to the external flash’s 
manual.

Use the M shooting mode on the camera when using any commercially available flash 
except for the flashes specified for this camera. For details on non-specified commercial 
flashes, see “Non-specified commercial flashes” (

g P. 42).

Set the shooting mode to M mode, then set the aperture value and 
shutter speed.

• Set the shutter speed to 1/180 sec. or slower. If the shutter speed is faster than this, 

commercially available flashes cannot be used.

• A slower shutter speed may produce blurred images.

• Be sure to turn on the flash after attaching the flash unit to the camera.

• Refer to the flash’s manual for instructions on how to set its flash control mode.

1) Exposures when using a flash require that adjustments be made on the flash. If a flash is 

used in the auto mode, match it with the f value and ISO sensitivity settings on the camera.

2) Even if the flash auto f value and ISO sensitivity are set the same as on the camera, the 

correct exposure may not be obtained depending on the shooting conditions. In such a 
case, adjust the auto f value or ISO on the flash or calculate the distance in the manual 
mode.

3) Use a flash with an illumination angle that matches the focal length of the lens. The focal 

length of the lens for 35 mm film is approximately twice as long as the focal length of the 
lenses designed for this camera.

4) Do not use a flash unit or other accessory TTL flash that has additional communication 

functions other than the specified flashes, since it may not only fail to function normally, 
but may also cause damage to the camera’s circuitry.

x Notes

• The flash fires each time the shutter is released. When you do not need to use the flash, turn 

off the flash’s power.

• Check beforehand that the flash you are using is synchronized with the camera.

Super FP flash

Detailed display on the control panel

s0013_e_00_unified.book  Page 42  Monday, March 5, 2007  10:04 AM