Ознакомительное Руководство для Olympus fe-220

   EN

• Charge the battery with the charger.

• Battery performance declines in low temperatures, and the charge may not be 

sufficient to turn on the camera. Remove the battery and warm it by putting it in your 
pocket for a while.

• To save battery power, the camera automatically goes into sleep mode and the 

monitor turns off if there is no operation when the camera is turned on (when the 
lens is extended and the monitor is on). No picture is taken even if the shutter 
button is fully pressed in this mode. Operate the zoom lever or other buttons to 
restore the camera from sleep mode before taking a picture. If the camera is left for 
12 minutes, it automatically turns off (the lens retracts and the monitor turns off). 
When the power is turned on in the playback mode, the camera does not enter the 
sleep mode but just turns off automatically after about three minutes. Press o 
to turn the camera on.

g

• No pictures can be taken when the shooting guide is being displayed. Take pictures 

after setting target terms by following the shooting guide or set it to the setting other 
than 

g in shooting mode.

• Wait until the 

# (flash charge) mark stops blinking before pushing the shutter 

button again.

• No date and time have been set in the camera at the time of purchase. Set the date 

and time before using the camera.

g“Set date and time” (P.6), “X Setting the date and time” (P.28)

• The date and time settings will be returned to the factory default settings if the 

camera is left without batteries for approximately 1 day. If batteries are inserted but 
removed to soon, the settings may be returned to the factory default setting in less 
than 1 day. Before taking important pictures, check that the date and time settings 
are correct.