Инструкция С Настройками для Olympus SZ-16

58 EN

If the camera does not work as intended, or if an 
error message is displayed on the screen, and you 
are unsure of what to do, refer to the information 
below to fi x the problem(s).

 

● Insert recharged batteries in the correct 

direction.

“Inserting and removing the battery and card 
(commercially available)” (p. 4), “Charging the 
battery” (p. 5)

 

● Battery performance may have been reduced 

temporarily due to low temperature. Take the 
batteries out of the camera, and warm them by 
putting them in your pocket for a while.

“Error message” (p. 60)

 

● It is likely that there is a high level of moisture 

inside the camera. Before using the camera 
again, remove the battery and memory card 
and dry fully with the battery/card cover open.

 

● Cancel sleep mode.

To save battery power, the camera 
automatically goes into sleep mode and the 
monitor turns off if there is no operation for 
3 minutes when the camera is turned on. No 
picture is taken even if the shutter button is 
fully pressed in this mode. Operate the zoom 
lever or other buttons to restore the camera 
from sleep mode before taking a picture. If 
the camera is left for another 5 minutes, it 
automatically turns off. Press the n 
button to turn the camera on.

 

● Press the 

q button to switch to the shooting 

mode.

 

● Wait until 

#(fl ash charge) stops blinking 

before taking pictures.

 

● With prolonged camera use, the internal 

temperature may increase, resulting in 
automatic shutdown. If this occurs, wait until the 
camera has suffi ciently cooled. 
The camera’s external temperature may also 
increase during use, however this is normal and 
does not indicate malfunction.