Эксплуатация Оборудования для Netgear EDA500 – ReadyNAS Expansion Chassis 5-Bay, Diskless

Use the boot menu to restart or troubleshoot your ReadyNAS storage system. Your storage system has the
following boot modes:

Normal. Initiates a normal boot process, just like booting using the Power button.

Factory default. Initiates a short disk test that takes approximately 5 minutes. After the disk test, a
10-minute time-out period begins.

If you want to cancel the factory default process, power off the storage system before the 10-minute
time-out ends. The system powers down safely without causing any data loss.

If you want to reset the system to factory default settings, do not power off your system. After the
10-minute time-out period, the factory default process begins.

To start the factory default process immediately, press the Backup button during the
10-minute time-out period.

OS reinstall. Reinstalls the firmware from the internal flash to the disks. Use the OS reinstall boot mode
when the system crashes and corrupts some configuration files. OS reinstall boot mode also resets
some settings on your storage system, such as Internet protocol settings and the administrator password,
to defaults.

Tech support. Boots into a low-level diagnostic mode. Use the tech support boot mode only when a
NETGEAR technical support representative instructs you to do so.

Volume read only. Mounts a volume as read-only. Use this option when you are attempting to rescue
data off a disk during a disaster recovery.

Memory test. Performs a memory test. The memory test runs for eight hours. The current status and
the pass or fail result is reported using the storage system LEDs, as described in the following table:

Figure 10. Memory Test Status

Blinking

Off

Off

Off

1st hour

Off

Blinking

Off

Off

2nd hour

Off

Off

Blinking

Off

3rd hour

Blinking

Blinking

Blinking

Off

4th hour

Blinking

Off

Off

On

5th hour