Руководство По Установке для KitchenAid KXW9748YSS

1.  Determine and make all necessary cuts in the wall for the 

vent system. Install the vent system before installing the 

range hood. See the “Venting Requirements” section.

2.  Determine the location where the power supply cable will 

be run through the wall. Be sure that the location will be 

covered by the chimney of the range hood.

3.  Drill a 1

1

/

4

" (3.2 cm) hole at this location.

4.  Pull enough power supply cable through the wall to allow 

for easy connection to the terminal box.

5.  Install the 10" (25.4 cm) square x 10" (25.4 cm) round 

transition with damper to the top of range hood using 

the 3 - 4.2 x 8 mm screws.

NOTE: Your range hood requires you to purchase either an 

internal type or an in-line (external type) blower motor system.
For internal blower systems, there are blower motor mounting 

parts in the blower motor installation packet that must be added 

to the range hood prior to mounting the range hood to the wall. 

See the “Install Range Hood Internal Blower Motor” section and 

the instructions supplied with the blower motor.

Install Range Hood

1.  Remove the grease filter. See “Range Hood Care” section.
2.  Using 2 or more people, hang range hood on 2 mounting 

screws through the mounting slots on back of range hood.

3.  Level the range hood and tighten upper mounting screws.
4.  Install 2 - 5 x 45 mm lower mounting screws and tighten.

Install Range Hood Internal Blower Motor

NOTE: Your range hood requires you to purchase an internal 

type blower motor system. See “Blower Motor System” in the 

“Accessories” section.

IMPORTANT: Perform steps 1-4 before mounting the 

range hood.
1.  Remove grease filters from range hood. See the 

“Range Hood Care” section.

2.  Install the 6 mm nuts to the outside top of the range hood 

at the proper location for the selected motor system.

 

■

Two 6 mm nuts are required for the single motor system. 

Clip the nuts into the small square notches located at the 

left and right sides (centered) of the square to round vent 

transition.

 

■

Five 6 mm nuts are required for the dual motor system. 

Clip the nuts into the small square notches, one located 

in the front of the square to round vent transition and the 

other four located at the left and right ends of the square 

to round vent transition.

3.  Disconnect the electrical connector to the heat lamp.