Справочник Пользователя для Zanussi ZBB47460DA

10

6. Use the same screws for vertical alignment

of the small doors.

7. If necessary, carry our horizontal alignment

by shifting the small doors.

8. After aligning the doors, tighten the nuts of

the brackets and the screws of the small

bracket.

9. Fix the shorter and longer bracket located

under the door to the panel with the two

plastic washers contained in the box of

accessories.

10. Then refit the bracket cover.

Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make a cut

out as shown.

820
870

170
220

140
190

30

100

900

• If using a plinth higher than 100 mm but less

than 140 mm, cut the height compensation

strip supplied with the appliance to the

required depth and fit it between the plinth

and the ventilation grille, pressing it into

position below this grille.

• If using a 100 mm plinth, fit the complete

height compensation strip.

140
190

Alignment height of 870 mm
• If using a 190 to 220 mm plinth, make a cut

out as shown.

100
150

30

100

• If using a plinth higher than 150 mm but less

than 190 mm, cut the height compensation

strip supplied with the appliance to the

required depth and fit it between the plinth

and the ventilation grille.

• If using a 150 mm plinth, fit the complete

height compensation strip.

• If the appliance is installed at the end of a

row of units, insert foot E to hold the plinth in

place.

1. Fit the appliance into the recess.

2. Rotate the bracket of 180° in order to

obtain the right position ( 2). The position

(1) is on the delivery.