Справочник Пользователя для Bosch TES-50621 RW

Скачать
Страница из 124
6
Robert Bosch Hausgeräte GmbH
en
Switching on the appliance
1.  Place the fully automatic espresso ma-
chine on a fl at, water-resistant surface 
that can take its weight. Make sure that 
the machine’s ventilation slots remain 
unobstructured.
2.  Pull the power cord out of the storage 
compartment (22) and plug in. Adjust 
the length of the cable by pushing it 
back in or pulling it out. The easiest way 
to do this is to place the appliance so 
that its back is fl ush with the edge of the 
counter and either pull the cable 
down-
ward or push it upward.
3.  Install the milk frother. Operate the ma-
chine only after the milk frother (6) has 
been fully assembled and installed. 
4.  Lift the lid of the water tank (18).
5.  Remove and rinse the water tank (17) 
and fi ll it with fresh cold water. 
Do not fi ll above the 
max mark.
6.  Replace the water tank (17) and push it 
fi rmly downward into place.
7.  Close the lid of the water tank (18) 
again. 
8.  Fill the bean container (1) with coffee 
beans. (For preparation using ground 
coffee, see “Preparation using ground 
coffee” on page 9.)
9.  Press the power switch 
O / I (9). The 
display (16) shows the menu for setting 
the display language.
10. Select the required display language 
with the upper rotary knob (15). The fol-
lowing languages are available:
English 
Nederlands
Français 
Italiano
Svenska 
Español
Polski 
Magyar
Türkçe 
Dansk
Norsk 
Suomi
Português 
Čeština
ελληνικα 
български
русский
11. Place a receptacle under outlet (6a).
12. Press the 
start button (10). The 
 language you selected is saved.
The appliance heats up and rinses. Some 
water will run out of the coffee outlet. 
When the drink selection menu is shown in 
the display, the appliance is ready for use.
Switching off the appliance
If the appliance has not been used for 
an hour, it rinses automatically and then 
switches off (time span can be programmed, 
see “Menu settings” 
Shut off 
on page 8). 
Exception: The appliance switches off with-
out rinsing if only hot water or steam were 
dispensed.
To switch the appliance off manually before 
this, press the 
e
 
off / 
j
 button (13). The ap-
pliance rinses and switches off.
N.B.: If the appliance is being used for the 
fi rst time, a service program has been run, 
or the appliance has not been operated 
for a long period, the fi rst beverage will 
not have the full aroma and should not be 
consumed.
When using the espresso machine for the 
first time, you will achieve a suitably thick 
and stable “crema” only after the first few 
cups have been dispensed.
After extended use, water droplets may 
form on the ventilation slots. This is normal.
TES506_1RW.indb   6
16.06.2011   13:51:06